Mattstillwell.net

Just great place for everyone

# What is normal voltage for alternator?

## What is normal voltage for alternator?

A good alternator should produce about 13.5 to 14.5 volts with the engine idling. If the voltage reading is low (12.5 volts or less), it indicates a charging problem but does not tell you what’s causing it.

Is 15 volts too high for alternator?

Higher than 15 volts indicates a fault in the charging system’s voltage regulator or related circuits. If it’s substantially excessive, this can cause electrical system and/or battery damage. You mentioned your voltmeter runs at about 15 volts most of the time.

### Is 13.8 volts good for alternator?

At that point, if the voltage falls between 12.6 and 13.7 volts, you need to replace your alternator. If it’s greater than or equal to 13.8 volts, a voltage drop test needs to be performed.

What should a 12 volt alternator charge at?

13.5-14.5 volts
A good alternator should put out between **13.5-14.5 volts. Stress test the alternator – Place a load on the alternator by turning on the headlights, the radio and the air conditioning. The voltage should remain high with these circuits on.

## Is 14.7 volts too high for alternator?

To fully charge in reasonable times, alternator output must be 14.2 V to 14.5 V as measured right across the battery posts. Above 14.5 volts charging voltage, batteries have a greatly increased tendency to release excessive acidic vapors, hydrogen gas, and to corrode things around the battery.

Is 15.2 volts too high for alternator?

Normal charging on these is 14.5 to 15 volt, any meter could vary enough to get the 15.2. Meaning no problem.

### Is 14.7 volts overcharging?

If your battery has a charge between 12.4V and 12.7V, your battery is fully charged and ready to run. If your voltage is below 12.2V, it needs to be recharged. Take a 30-minute drive on the highway or pick up a charger to bring the voltage back up. If your voltage is higher than 12.9V, the battery is overcharged.

What should alternator voltage be at idle?

HOW TO TEST ALTERNATOR CHARGING VOLTAGE. Most alternators that are charging properly should produce a voltage of about 13.8 to 14.2 volts at idle with the lights and accessories off. Always refer to the vehicle manufacturer’s specifications.

## Is 14.5 volts overcharging?

Is 14.8 volts too high for alternator?

A good alternator should maintain battery voltage between 13.9 and 14.8 volts (14.2 is optimum). Even worst-case, with all accessories turned on, there should be at least 13 volts at the battery.

### Is 13.2 volts good for an alternator?

A good alternator should maintain battery voltage between 13.9 and 14.8 volts (14.2 is optimum).

Should an alternator always put out 14 volts?

## How do I know if my alternator is overcharging?

Symptoms of Your Car Alternator Overcharging:

1. Car Battery Voltage Gauge Reading is High. You notice a high voltage reading on your cars vehicle’s dashboard.
2. Car Battery Gets Hot When Charging.
4. Your Car Battery is Bulging on Sides.

What should my alternator be charging at idle?

Most alternators that are charging properly should produce a voltage of about 13.8 to 14.2 volts at idle with the lights and accessories off.

### Can a bad battery cause an alternator to overcharge?

This error is triggered when the ECU detects a high voltage somewhere in the charging system. It often points to an overcharging alternator, but can also be caused by problems elsewhere such as a bad voltage regulator, bad battery wiring, or corrosion at the battery terminals.

How do I know if my alternator voltage regulator is bad?

Symptoms of a bad voltage regulator may include:

1. High voltage output.
2. Low voltage output, sometimes.
3. No voltage output.
4. Lights dim or flicker.
6. Engine working erratically (weak or flickering ignition system)
7. Adding water to the battery frequently.

## What are the symptoms of a faulty voltage regulator?

Below is a more detailed list of the six most common symptoms of a bad voltage regulator.

• Too High Voltage in the Battery. There are two ways a voltage regulator can fail.
• Battery Light or Check Engine Light.
• Inconsistent Operation of Electrical Components.
• Vehicle Dies While Running.
• Dimming/Pulsing Lights.

What are signs of alternator failure?

7 Signs of a Failing Alternator

• Dim or Overly Bright Lights.
• Slow or Malfunctioning Accessories.
• Trouble Starting or Frequent Stalling.
• Growling or Whining Noises.
• Smell of Burning Rubber or Wires.
• Battery Warning Light on Dash.

### How do I know if my alternator or voltage regulator is bad?

Another way you can tell the voltage regulator is bad is when the car lights keep dimming or flickering. After all, the voltage regulator is supposed to keep the power flowing to the lights, so it’s no surprise that those lights don’t work right anymore once this part goes bad.

Can a blown fuse cause alternator problems?

A blown alternator fuse will prevent the charging system from working properly, leading to a variety of problems that can mimic a bad alternator.

## How do I check if my alternator is working?

How to Test an Alternator – YouTube

What are the symptoms of a failing voltage regulator?

• Too High Voltage in the Battery.
• Battery Light or Check Engine Light.
• Inconsistent Operation of Electrical Components.
• Vehicle Dies While Running.
• Dimming/Pulsing Lights.

### What happens when the voltage regulator goes bad?

A bad voltage regulator can even affect your car’s engine. For example, as this car part stops working properly, you might notice your car’s engine sputters or stalls once in a while. It might also have trouble accelerating as you drive.

What fuse controls the alternator to battery?

But when someone mentions the “alternator fuse”, they’re generally referring to the primary, high-amperage fuse (or fusible link) between the alternator and the battery. Like any fuse, the primary alternator fuse acts as a circuit protection device.