How do I identify a 46RE transmission?
The identification plate is attached to the right side of the transmission case. The 42RE/44RE/46RE is a 4-speed fully automatic transmission with electronic governor. The ID numbers are stamped on the case’s left side just above the oil pan.
How much fluid does a 46RE transmission hold?
10
Transmission Fluid
| Manufacturer | Transmission Type | Fluid Amount (quarts) |
|---|---|---|
| DODGE | 46RE | 10 |
| JEEP | 46RE | 10 |
What years did dodge use the 46RE transmission?
The 46RE can be found in a number of different rear wheel drive Chrysler products from 1995 through 2002, and some early-production 2003 Dodge Ram pickup trucks that had the 5.9L Magnum V8. In its previous iteration, the 46RH was found in earlier vehicles from 1990 through 1998.
How much is a 46RE transmission?
46RE Transmission – $2,195 | 5-Year Warranty | Money Back Guarantee.
What controls reverse in a 46RE transmission?
Reverse uses the Front clutch, Rear (low-reverse) band and Direct clutch. If you have 3rd and OD, the Front clutch is probably OK. If you have forward gears, then the Direct clutch is probably OK. If you have manual 1st gear, then the Rear band is probably OK.
How many gears does a 46RE have?
A 46RE transmission has a total of five gears. They are 1, 2, 3, 4, and Reverse.
Do you add transmission fluid while car running?
Your car’s engine should be running when you add fluid to the transmission, but you should have the transmission in park and the handbrake activated for safety. Check the owner’s manual for instructions on selecting the correct transmission fluid for your vehicle.
What vehicles had the 46RE transmission in it?
A518 (46RH/46RE)
- Dodge Ram pickup and vans 150/250/350 V8 and diesel engines (DGT)
- Dodge Ramcharger SUV 1988-1993 5.2L & 5.9L V8.
- Jeep Grand Cherokee 1993 5.2L, 1998 5.9L.
- 1995 Dodge Dakota 5.2L Magnum V8.
- 1996 Dodge Dakota V8.
- 1998–2003 Dodge Dakota R/T.
- 1998-2003 Dodge Durango 5.9L V8 (4WD or 2WD)
What gear set does a 46RE have?
Control of the 46RE
They use a sun gear and two planetary gear sets. They had three forward gears and reverse, with the driver controlling the gear by pressing buttons built into the dashboard rather than the more customary gear shift lever. You could find these gear buttons at the far left of the dash.
How do you adjust the bands on a 46RE transmission?
How to adjust bands and change automatic transmission fluid
What happens if you put too much transmission fluid in your car?
Too much transmission fluid leads to an excessive pressure build-up, and the seals can only handle so much. When this happens it can lead to some of the seals cracking or failing, and you’ll start to notice transmission leaks as a result.
Is it OK to overfill transmission fluid?
Foaming Fluid: Overfilled transmission fluid will cause foaming. Once the foaming occurs, it’ll lead to several transmission issues, such as inadequate lubrication, overheating, hard shifting, etc. Over time, it could damage the entire system beyond repair.
What Jeep has 46RE transmission?
The electronic units found in the Jeep Grand Cherokee from 1993 to 1998 feature the updated 46RE. This Jeep addition to the online and offline inventory of transmissions marketed by the Got Transmissions company is expected to open up a new resource for buyers.
What are symptoms of loose transmission bands?
Signs include:
- Engine revs or chugs.
- Slow, weak or delayed acceleration.
- Difficulty shifting gears or hard shifting.
- Grinding, whining or other strange noises.
- Won’t go in reverse.
- Burned or strange smells.
- Check engine light.
What does tightening the bands on a transmission do?
In some transmissions, part of the operating controls include “bands”: metal straps with friction material on one side. When applied, the bands tighten around drive components to hold them in place.
Do you leave the car running to put transmission fluid in?
Leave car in neutral or park. Let engine warm up and continue to run throughout operation unless vehicle’s owner’s manual says otherwise. (Be aware that some automatic transmission fluid levels are checked with the engine off. Check owner’s manual.)
Does car need to be running to put transmission fluid in?
What are the symptoms of an overfilled transmission?
Symptoms of Overfilled Transmission Fluid
- Transmission Fluid Leaks.
- High Fluid Level On Transmission Dipstick.
- Trouble Changing Gears.
- Strange Noise From Transmission System.
- Overheated Engine.
- Slipping Gears.
- Burning Smell.
- Slow Acceleration.
Can I add Lucas transmission fix to a full transmission?
How to Use Lucas Transmission Fix. For best results, have your transmission oil and filter changed before adding Lucas. However, you can add it to your existing transmission fluid by simply removing the transmission dipstick and using a funnel to pour it in.
What did the 42RE transmission come in?
The 42RE transmission was first introduced in Dodge and Jeep vehicles in 1993: Dodge Ram 1500 pickup, Dodge Ram B150 Van, Dodge Dakota, Jeep Grand Cherokee, and the Dodge Durango.
How do you adjust the bands on a 46re transmission?
Can you add Lucas transmission fix to a full transmission?
What happens when you overfill an automatic transmission?
If you overfill it, the transmission will experience hard shifting and slippage. Another consequence of overfilling your transmission is that it will cause the fluid to lose its lubricating properties. It could also lead to the entire system blowing up and not functioning.
What happens if you overfill transmission fluid?
Foaming Fluid: Overfilled transmission fluid will cause foaming. Once the foaming occurs, it’ll lead to several transmission issues such as inadequate lubrication, overheating, hard shifting, etc. Over time, it could damage the entire system beyond repair.
Do you check transmission fluid in park or neutral?
Turn on your car, leaving it in park, and let the engine run for a few minutes to warm up. Transmission fluid expands in heat and in order to receive accurate results, it must be under normal operating conditions. If the fluid is checked when the engine is cold, you may get false results indicating the fluid is low.